To copy Toolboxes and/or MenuBars from ustn.m01 files into a .dgnlib it's basically copy and paste. Listed below are the general steps: Verify the ustn.m01 file is correctly configured in the workspace and the menus/toolboxes are available for display Create .dgnlib file to store the V8i menu bar. This .dgnlib file must be referenced by the MS_GUIDGNLIBLIST variable. Open the .dgnlib file in MicroStation Open Workspace -> Customize Locate the MenuBar/Toolbox items from the ustn.m01 file Copy those items to the clipboard (Right mouse click > Copy) If the ustn.m01 resource is a MenuBar item then at the top of the MenuBar section select Main Menu and Paste the item there. This will copy the MenuBar item from the ustn.m01 file into your .dgnlib. It will immediately show up at the end the MicroStation MenuBar. You can drag it and drop it to another location in the MenuBar if you wish. If the ustn.m01 resource is a Toolbox item Paste it the .dgnlib entry in the left panel of the Customize dialog. This will create a new toolbox in the .dgnlib file To create a MenuBar item from a Toolbox simply click+drag the Toolbox and drop it to the desired location in the MenuBar section of the dialog. Exit MicroStation Remove the ustn.m01 file from your workspace.
↧