[quote userid="1113205" url="~/products/microstation/f/microstation-forum/213332/minimum-measure-not-working-as-well-as-it-did/666015"]I had in fact mentioned the same problem occurred for 'construct a minimum distance line' in early details at the top this thread[/quote] Yes, but the defect was created for "measure minimum distance", not for any other issue. [quote userid="1113205" url="~/products/microstation/f/microstation-forum/213332/minimum-measure-not-working-as-well-as-it-did/666015"]As an engineer I just expect the software to function correctly[/quote] Well, we all do ... errr ... not, as developer, I know that no software works correctly ;-) ... but a number of issues have to be maintained on some minimum level. [quote userid="1113205" url="~/products/microstation/f/microstation-forum/213332/minimum-measure-not-working-as-well-as-it-did/666015"]I do not want to spend time having to detail every problem I encounter then wait months to be fixed for a new version.[/quote] It's hard to avoid it: Until problem is reported, is cannot be fixed. But, when all issues, reported (only) in this forum would be fixed, not many left to be reported ;-) Unfortunately (even when U16 finally contains quite a lot of fixes), the pace of repairs and fixes is extremely slow. [quote userid="1113205" url="~/products/microstation/f/microstation-forum/213332/minimum-measure-not-working-as-well-as-it-did/666015"]I'm increasingly disappointed that such a great CAD software has so many problems.[/quote] Unfortunately, it's a common feeling of many users, especially when working in 3D and/or with DWG data :-( Regards, Jan
↧