Hi Pascal, Thank you very much for the tip. I think I was able to follow the steps, but do have some problems extracting the centerlines (7). First of all I have not used Descartes much so I might be using some wrong settings on the "fit cylinder" tool as I was not able to extract much from the few points in the POD file. I see i have only outer diameter end points in the POD i created, is that enough points to be able to extract the centerlines? ( or solids with bends ) Are there any other settings that can create points everywhere on the surface maybe? I might have attached the file i was trying to extract if you want to have a look ( if i have done this correctly) (Please visit the site to view this file)
↧